Intelligent Automatic Water Pump Motor Controller , Wireless Water Level Controller

Automatic water supply intelligent water pump controller

The automatic pump controller is simple and efficient. When the pump is started to pump water, it is often forgotten to shut it down, resulting in waste of electricity and water. The installation of the fully automatic pump is simple and efficient to solve the start and stop of the pump. When the pool is filled with high water level, the pump water supply is stopped by the sensor signal. When the pool is at low water level, the sensor signal starts the pump to pump water.

The automatic water pump controller adopts digital core with overload, no load and ultra low voltage protection. The upper and lower levels and pressure are automatically controlled in one.

Can be connected to float control, pressure gauge control and probe sensor control

Description of the display and operation area

Description of wiring connection and parameters setting area

Wiring connection for both lower pool and upper pool water level control

Under this mode, the no-load protection value must be set as 0.00A.
When the upper pool water level reaches to middle level, the controller starts the pump, and it stops
at the high level of upper pool.
When the lower poor water level reaches to high level, the pump controller will start the pump, and it
stops at middle level of lower pool.
Both of the low level probes are used to make a close-loop circuit

Selection Guide