Payment & Shipping Terms:
|Starting Torque:||0.5Hz/150% Torque, Speed Ratio 1:100, Dynamic Response <20ms, Steady Speed Accuracy ±0.2%||High Reliability:||Mature And Reliable Drive, Protection Circuit Design, Anti-interference Design|
|High Overload Capacity:||150% / 120s, 160% / 60s, 180% / 10s, 200% /1s||Intelligent Control:||Speed Sensorless Open Loop Vector Control|
|Dual Display Keyboard:||Dual Display LED Keyboard One Row Can Be Switched, Two Rows Of Parameter Settings||Pulse:||High Speed Pulse Input And Output|
vfd motor drive,
ac frequency converter
Kinda 37KW Motor Frequency Converterapplied In Plastic Extruder
1, Load feature
There is a screw rotates in the tube body to push the plastic material move ahead, the screw type
will increase the pressure to overcome the big resistance.
Plastic extruder is constant torque load, it needs high output torque, and meantime the
temperature on the site is always high and dust will be more.
2, Requests for frequency inverters (VFD)
(1) Control is simple.
(2) Output high torque at low frequency..
(3) Heat sink performance of frequency inverter must be good.
3, Instruction for commissioning
(1) Pictures of plastice extruder
(2) Parameters setting list
|No.||Function codes||Default||Setting value||Explanation|
|2||F0-02||0||1||External start / stop signal|
|3||F0-03||1||2, 3, 4||External analog signal to control the output frequency|
|4||F0-17||Model depend||Power * 2||Set the acceleration time based on real request|
|5||F0-18||Model depend||Power * 2||Set the deceleration time based on real request|
(3) Typical wiring diagram
(1) During commissioning, the motor running direction must be checked correctly.
(2) Before starting the motor, the system temperature must be ready, if the temperature is not
ready, the material inside the tube body will be blocked, it will cause high start current, the
failure of overload will happen.
(3) Maintenance regularly, pay attention to dust prevention and heat sink for frequency inverter.
Contact Person: Tim